Keep your drip irrigation tubing neatly in place with this compact and easy-to-print stake.
I designed this stake after struggling with commercial irrigation stakes that were often too long and difficult to push into firm or compact soil. This design provides a lower-profile alternative that is easier to install while still holding 13 mm (1/2") drip irrigation tubing securely.
The open clip allows the tubing to be pressed into place without disconnecting any irrigation components, and the lightweight structure keeps print time and material usage low.
Features
Designed for 13 mm (1/2") drip irrigation tubing
Compact design for easier installation in firm soil
Open snap-fit clip for quick tubing insertion
Lightweight structure reduces filament usage
Optimized for FDM 3D printing
Prints flat without supports
Suitable for PETG, ASA, PLA, and similar materials
Included Files
STL file ready for slicing and printing
Printing Recommendations
Material: PETG recommended for outdoor use
Layer height: 0.20 mm
Print flat on the build plate
No supports required
Use a brim for improved bed adhesion
Adjust clip scaling if needed to match tubing tolerances and printer calibration
Keep your drip irrigation tubing neatly in place with this compact and easy-to-print stake.
I designed this stake after struggling with commercial irrigation stakes that were often too long and difficult to push into firm or compact soil. This design provides a lower-profile alternative that is easier to install while still holding 13 mm (1/2") drip irrigation tubing securely.
The open clip allows the tubing to be pressed into place without disconnecting any irrigation components, and the lightweight structure keeps print time and material usage low.
Features
Designed for 13 mm (1/2") drip irrigation tubing
Compact design for easier installation in firm soil
Open snap-fit clip for quick tubing insertion
Lightweight structure reduces filament usage
Optimized for FDM 3D printing
Prints flat without supports
Suitable for PETG, ASA, PLA, and similar materials
Included Files
STL file ready for slicing and printing
Printing Recommendations
Material: PETG recommended for outdoor use
Layer height: 0.20 mm
Print flat on the build plate
No supports required
Use a brim for improved bed adhesion
Adjust clip scaling if needed to match tubing tolerances and printer calibration